OVERVIEW: Chemcote was engaged to provide long term protection to assets in a highly aggressive environment. Salt water mains supplying a condenser were externally corroded, and the requirement was for urgent repairs with minimal disruption to plant operation. A 20 year life extension is expected using Chemcote’s solution.
INDUSTRY
ENVIRONMENT
Industrial immersed areas
SUBSTRATE
Mild steel pipework with extensive external corrosion due to steam from pit below and salt water leaks from above
CHALLENGE
Carry out external corrosion protection to equipment in situ
SOLUTION
Apply Epo-Chem™ RS 500P @ 100 microns
Apply Epo-Chem™ RA 500M in one coat @ 350-400 microns total DFT
Apply 1 coat of Epo-Chem™ RC 500GTC Jade Green
Unmask and detail
SCOPE
Check for sharp edges and remove any weld spatter
Mechanically clean loose corrosion using needle gun and wash down
PRODUCTS
OUTCOME
Chemcote’s solution has extended the life of this asset by 12-24 months, and delivered a 30% improvement in functioning. Continuous high performance is guaranteed until our review at the next planned outage.
RELATED CASE STUDIES
Stern Tube Life Extension During Half-life Refit
Patrol boat in slipway for refit Protection against abrasive blasting damage Application of RB364 Tube internal lining complete Overview: The half-life refit of critical components
Air Receiver Restoration for Long-Term Durability
Pitting corrosion near shaft landing After first abrasive blasting After 2nd Abrasive blast holes were found requiring composite reinforcement Filling void in difficult to reach
High Performing Replacement for 316L SS
On inspection flange corrosion Deep pitting on forged section Application of 1st coat Ready to be put into service for 25+ years of life OVERVIEW: