OVERVIEW: The fan required pressure washing every 3-6 months to prevent large amounts of build up. This build up was causing balancing issues and unnecessary bearing load.
Chemcote was engaged to improve the efficiency of the fan, decrease problems with build up, and reduce maintenance and associated costs.
INDUSTRY
SUBSTRATE
2.8m Diameter Fabricated Steel Ventilation Fan
CHALLENGE
Prior to Chemcote’s involvement, the fan required pressure washing every 3-6 months to prevent large amounts of build up. This build up was causing balancing issues and unnecessary bearing load.
Chemcote was engaged to improve the efficiency of the fan, decrease problems with build up, and reduce maintenance and associated costs.
SOLUTION
Chemcote recommended a design which included an abrasive resistant lining to improve laminar flow with a low friction finish to reduce the amount of build up, and reduce ongoing maintenance costs.
SCOPE
Grind welds, sharp edges and remove weld spatter
Abrasive blast to class 2.5
Apply primer: RS 500P
Apply ceramic filled epoxy RP 500Balancing on coating completion and touch up
PRODUCTS
OUTCOME
The ventilation fan was inspected after its return to service at 6 months and again after 12 months. The inspections found significant improvement including reduced build up and better balance.
This system is now being used for a number of different mineral extraction facilities.
RELATED CASE STUDIES
Fast Curing Abrasion Protection
Condition of surface before mechanical preparation RB 364 applied to spot abrasive blasted surfaces Pugmill externals Coating with InD Cote OVERVIEW: Chemcote’s specialist team
Split Case Salt Water Pump Refurbishment
Apply protection to all machined surfaces Application of 1st coat RB 364 Apply Ceram-Chem RP500 Ready to return to service for another 15+ years of
Composite Pipe Repair
Flange is barely attached Repairs commence Repairs using composite weave mat Coating complete OVERVIEW: A power station client required corrosion protection for a 30-plus
